Product Overview

Exacticide Applicator Duster - PFC Complete Kit is a fine granule applicator and electric power duster with a non-adjustable and an adjustable flow rate from low to medium and vice versa. This applicator is battery operated allowing the versatility required to complete various types of job if not all. It provides precise application of all fine granules while preventing over application making it a cost-efficient choice. This applicator system is proven to be a multifaceted pest eradication tool which can be used for exterior and interior applications. Cracks and crevices including hard to reach areas are now easy and uncomplicated targets with this applicator. It comes with a carrying case making storage easy. Each Exacticide Application Duster comes with a carrying case, a rechargeable Makita battery, a battery charger, 2 dust canisters, and 2 12-inch wands.

Do not mix dust, unless authorized by Technicide. Do not use Drione in the Exacticide. Do not use large granules, only use granules with “FG” in the name or on the label. “FG” stands for fine granule. Do not use liquids in the Exacticide.

This PFC Complete Kit model has an adjustable flow rate option – if you only want a fixed flow rate, you will want the Exacticide Applicator Duster - Legacy Entry Model Kit.

Product Documents

Technicide Exacticide Duster Manual

Features and Specs

For use in	Interior & Exterior Applications: Cracks & Crevices, Voids Pathways, Eaves, Perimeters, Trees and other hard to reach areas
Application	* See manual for complete application instructions
Voltage	110v
Wand Length (in.)	12 in.
Parts Included	1 Carrying Case 1 Makita Battery 1 Battery Charger 2 Dust Canisters 2 Wands (12 inches)
Shipping Weight	5.00 lbs
Manufacturer	Technicide, Inc. (Mfg. Number: PFC)

Details

DIRECTIONS FOR USE:

Charge the Makita battery that came in with the applicator. Plug the charger into an 110V outlet, or car charger. Place the battery into the charger. Make sure the red light goes on. Allow 50 minutes for the battery to fully charge or 15 minutes for a quick charge.
Once the battery is charged, push the battery into the applicator until the gray tabs click into place. Squeeze the gray tabs and pull to release the battery.
Attach a pre-filled chemical canister to the applicator by turning it over so the trigger is on the top and the applicator is in a horizontal position. Remove the canister cap and twist the canister into the receiver of the applicator. Tighten the canister until snug but do not over tighten. Also, take care to not to cross the threads. When secure, turn the applicator over for operation.
To apply dust or fine granules, place the wand into the nozzle at the front of the unit then twist and push until snug. Turn the applicator upside down (trigger up, canister down), adjust the dial to the highest setting, and squeeze the trigger for 5 seconds in the direction of the target area. Now that the motor is warmed up, adjust the dial to your preferred setting, flip the applicator right side up, insert the tip into a crack, void or in the direction of the target area, and squeeze the trigger. Release the trigger to stop the application.
Please note that you must pause for 1 second between trigger pulls at the lowest settings.