Product Overview

The Bellow Hand Duster features new design enhancements that make it the “Professional’s Choice” when it comes to crack and crevice treatments of fine dust products into small areas. This bellow hand duster features a new bellows and spring that is much easier to compress and use than other similar dusters on the market. In addition, the clean-out rod comes with an o-ring for a tighter seal to prevent dust from escaping out the back of the duster. A 6.5 inch extension makes it easy to treat hard to reach places. The metal extension also features an insulated black tip to prevent a shock hazard when dusting near electrical outlets. To use the duster, fill the rubber container (bellows) half-way full with an insecticide dust product such as Delta Dust or Pyganic Dust. It is also recommended to place a small rock in the duster to help break up the dust and prevent it from clumping. Compressing the bellows will cause dust to escape the metal tip of the duster. Using a duster allows you to inject dust more easily into cracks and crevices or inside wall voids where insects like to hide. We highly recommend purchasing a duster when applying any dust products. Note: This hand duster does not come with an insecticide dust. You will have to purchase the dust separately.

Features and Specs

Yield	Holds up to 4 oz.
Dimensions	9.75 L x 2.75 W x 4.25 H
Material / Construction	Rubber bellow, metal extension
Special Features	5 in. extension tip (not removable), insulated black tip to prevent a shock hazard when dusting near electrical outlets, cleaning tool is stored in duster
Parts Included	Cleaning tool
Shipping Weight	0.45 lbs
Manufacturer	Executive Pest Control Products

Details

How to Properly Use the Bellow Hand Duster (Video)

Remove black rubber cap from top of the bellows. The duster should be filled only halfway with dust - no more than two-thirds full. This allows for adequate air space to create the desired air/dust mixture prior to application. If there is too much dust in the duster, clumps of dust on treated surfaces may result, leading to over application of the product and messy spills.

Between each squeeze, the duster should be shaken slightly to get dust floating inside the duster.

When applying dust into cracks and crevices and on surfaces, gently squeeze the duster to ensure the application of very thin layers of dust. When dusting correctly, you should barely be able to see the dust emerging from the tip of the duster.

Before relaxing your grip on the duster, pull it away from the surface or crack you are treating to prevent sucking up lint, moisture or debris. Small amounts of these items will eventually cause lumping and/or clogging of the duster. In the event that the nozzle becomes clogged, you may unscrew the rod from the rear of the nozzle and insert it into the nozzle to break up any clogs.

TIPS:

The easiest way (and correct way) to use the duster is upside down (with the bellows facing downward). Place several pebbles or small ball bearings in your duster to keep the dust agitated and ensure than any clumps are broken up prior to application.

Carry a small brush and a damp cloth. These can be used in the event that dust accidentally drifts out of cracks and crevices and onto non-target areas. Use the brush to push excess dust into cracks, and use the cloth to wipe up.